410-574-1287

Curbside Content

Applications 
Care 
Links 
Measurements 
Online Ordering 
Recycled 
Remodeling Tips 
Shipping 
Specifications 


Go to the Home Page

Specs

  1. Size: 6 in. x 6 in. x 1/2 in. high tile
    - interlocking design with anti-skid textured top surface and male/female locking edges
    - 212 supporting bosses per square foot
    - 5/16 in. maximum grid opening to prevent small heel penetrations
    - tapered edge pieces are 2 in. wide x 12 in. long
  2. Weight: .6 lbs. per square foot
  3. Colors:  available in many standard colors.
    Custom Coloring can be done in orders over 1000 square feet.
  4. Static Load:  will support concentrated loads in excess of 95 PSI
    (note: a typical car produces tire loads of 30-45 PSI).
    Plus, our tiles remain effective under load at temperatures as high as 180 degrees Fahrenheit
  5. Care and Maintenance:
    The easiest way to care for VersaTiles is to sweep them off.
    After a rain, just sweep away the water for a dry surface.
    If they get really dirty, just use a bit of soap and water. That's it...
  6. Properties:
    - chemically resistant (gas, kerosene and most household chemicals will not harm it)
    - mold, mildew, weather and UV resistant
    - non-absorbent
    - non-staining

Installing VersaTiles is literally a "snap"
( No Tools Required for Basic Installations )
The only tool needed  for "complex installations" is a simple tile knife

   A deck or balcony can be completed in less than an hour.

  • Just lay out the tiles and start snapping.

  • Or make a game of it and trick your kids into doing it.

  • Calculate the number of square feet you need (measure the length and multiply it
    by the width of the area to be covered).

  • Tapered edge pieces are 2 inches wide by 1 foot long;  you can choose to
    put them on any or all sides of your installation area, or just in high traffic areas.  

Start by laying your first panel on any corner.
( The Loops should be pointed in the direction you want to add the panels )
The Panels have 2 Sides with Female Loops and 2 Sides with Male Pegs.

This is the "CORRECT - WAY" ( with Loops pointing in the SAME Direction )

Always begin the installation in one corner, pointing the
"Female Loops in the Direction that Additional Tiles are to be Added.

This is the "WRONG - WAY" ( with Loops pointing in DIFFERENT Directions )

 Caution: If you inadvertantly rotate a tile 90 degrees, it will Snap into place
however, you will not be able to complete the installation properly.

Place the next tile over the "Female Loops" & gently push down until they snap together.